Before fitting your magnetic signs
Confirm the intended area is magnetic, smooth and flat. Wash and fully dry both the vehicle panel and the back of the sign. Dirt, grit or moisture trapped underneath can prevent a flat fit and may mark the finish.
How to fit them
Position one edge first, then smooth the magnetic panel down so the entire back makes contact with the vehicle. Do not bridge trims, deep recesses, sharp curves, rust, dents, filler or repaired areas.
Routine cleaning
Remove the signs regularly and clean and dry both surfaces before refitting. Take them off before automated vehicle washes and follow the care instructions supplied with your order.
Safe storage
Store signs clean and dry, preferably flat. When flat storage is not practical, roll them loosely with the printed side facing out. Never fold or crease magnetic panels.